Routine

Plaster cast and backslab principles (casting, splinting and cast complications)

plaster cast backslab splint immobilisation cast-complications procedure · Wounds & Procedures
Physician-written · Verified by three sets of doctors · Reviewed November 2026

Bedside summary

Practical reference for safe immobilisation in the ED. Acute injuries are splinted with a non-circumferential backslab (plaster of Paris or fibreglass slab) to accommodate swelling; full circumferential casts are avoided in the first 24-72 h after acute trauma or reduction. Good technique and clear cast-care advice prevent the serious complications of compartment syndrome, pressure sores, neurovascular compromise and VTE.

Red flags

  • Increasing pain not relieved by analgesia / pain on passive stretch (compartment syndrome) - split cast urgently
  • New numbness, tingling, weakness or colour/temperature change distally
  • Localised 'hot spot' pain under cast (pressure sore)
  • Calf pain/swelling suggesting DVT in a lower-limb cast
  • Foul smell or discharge (skin breakdown/infection) under cast

Assessment

Differential diagnosis

  • N/A - procedural reference
  • Distinguish cast-related pain (compartment syndrome, pressure sore) from expected fracture pain
  • Consider VTE if calf pain/swelling in a lower-limb cast
  • Consider neurovascular compromise if new numbness/weakness

Investigations

  • Document distal neurovascular status before and after application
  • Post-application/post-reduction X-ray to confirm position
  • Re-X-ray at follow-up (displacement in cast is common for unstable fractures)
  • Clinical reassessment for tightness/compartment syndrome if pain increases

Management

  • Use a backslab (slab, not full circumferential cast) for acute injuries and immediately after reduction to allow for swelling.
  • Protect the skin: stockinette then even wool/padding, extra padding over bony prominences; keep edges smooth.
  • Apply the slab in the functional/position of safety for the injury (e.g. wrist neutral-slight extension; ankle at 90 degrees; hand MCP flexed/IP extended).
  • Mould without finger indentations (which cause pressure sores); support until set; avoid heat burns from exothermic setting plaster.
  • Elevate the limb and encourage movement of free joints (fingers/toes) to reduce swelling.
  • Give explicit cast-care advice: elevate, keep dry, do not insert objects, and return immediately for increasing pain, numbness, tingling, colour change, or a tight/wet/cracked cast.
  • If a cast is too tight or compartment syndrome is suspected: split/bivalve the cast and padding down to skin and reassess urgently.
  • Assess VTE risk for lower-limb immobilisation and prescribe thromboprophylaxis per local policy.

Drugs & doses

Simple analgesia: paracetamol 1 g PO every 6 h + ibuprofen 400 mg PO every 8 h
Thromboprophylaxis for lower-limb cast if indicated, e.g. enoxaparin 40 mg SC once daily [verify local risk-assessment]
Procedural sedation/local anaesthesia agents as required for reductions [verify local]

Disposition

Discharge with analgesia, cast-care advice and fracture-clinic follow-up. Return immediately for red-flag symptoms. Admit if compartment syndrome or neurovascular compromise suspected.

Complications & pitfalls

  • Acute compartment syndrome under a tight cast
  • Pressure sores from inadequate padding or indentation
  • Neurovascular compromise
  • Thermal injury from setting plaster; skin maceration
  • Joint stiffness from over-long or malpositioned immobilisation; VTE

Exam pearls

  • Acute trauma = backslab, not a full cast - swelling needs room.
  • Never ignore increasing pain under a cast - split it down to skin and reassess.
  • Mould with the palm, not fingertips, to avoid pressure points.
  • Always give written cast-care and red-flag advice and document neurovascular status.
  • Don't forget VTE risk assessment for lower-limb casts.

Disclaimer: Educational decision support for qualified clinicians and students — not a substitute for clinical judgement, local protocols or a full drug reference. Confirm every dose and contraindication against your formulary before prescribing.